ADT NS GROUT is a pre-bagged, non-shrink, free-flowing cementitious precision grout made from Portland cement, graded fillers and chemical additives. It is designed for machine foundations, base plates, anchor bolts, bridge bearings, precast joints and structural grouting applications. Its controlled expansion system compensates for plastic-stage shrinkage and settlement, helping achieve full bearing contact and reliable load transfer. ADT NS GROUT is chloride-free, non-metallic and requires only the addition of clean water at site.
ADT NS GROUT is recommended for machine foundations, base plate grouting, anchor and HD bolt pockets, crane rails, precast joints, bridge bearings, structural repairs, jacketing and gap filling between steel and concrete interfaces. It can be used in flowable, pourable or dry-pack consistency depending on the application requirement.
Prepare the concrete surface by removing laitance, oil, grease and loose material. Pre-soak the concrete with clean water for 6 to 24 hours and remove standing water before grouting. Mix the full 30 kg bag mechanically with the specified quantity of clean water for 3 to 5 minutes until a uniform, lump-free consistency is achieved. Pour continuously from one side only while maintaining sufficient grout head to avoid air entrapment. Place the grout within 30 minutes of mixing and do not add extra water after setting begins. Cure exposed grout surfaces for a minimum of 3 days.
ADT NS GROUT is supplied in 30 kg moisture-resistant bags. Store unopened bags in a dry, covered area on pallets and protect them from moisture. Shelf life is 6 months from the date of manufacture when stored under recommended conditions.